Get Started; Charge The Built-In Battery - Philips SPH8208/12 User Manual

3 Get started

Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Charge the built-in battery

Caution
•
Never drop the product. When you drop the product, it
will be damaged.
Note
•
For the fi rst time use of your PhotoFrame, charge the
built-in battery.
Approximate time for charging the built-in
battery.
Set on
Set off
Standby mode
1
Connect the supplied power cord to the
supplied charging dock, fi x the cord to the
cord channel, and then connect the power
cord to a power supply socket.
5 hours
2.5 hours
3 hours
b
2
Connect the PhotoFrame to the charging
dock.
Tip
•
During charge, the LED indicators after the control
buttons on the front panel blink.
•
When the built-in battery is fully charged, the LED
indicators stop blinking and you can share your memories
with the PhotoFrame everywhere for up to 2 hours.
•
Battery life varies with use.
c
a
EN 11