Table of Contents
Advertisement
EN 8
4.
4. Mechanical Instructions
Index of this chapter:
1. Disassembly Procedures
2. Service Position
3. Picture Tube Replacement
4. Re-assembly
Notes:
•
Figures below can deviate slightly from the actual situation,
due to the different set executions.
•
Follow the disassembly instructions in described order.
4.1
Disassembly Procedures
Note:
•
Not all shown items are available for all models.
•
If you are servicing a CBA or speaker, you do not need to
remove the plastic Upper Back Cover.
1 2
1 3
1 2
1 2
1 2
1 2
1 1
1 1
1 1
1 1
1 1
Figure 4-1 Rear view
4.1.1
Lower Center Back Cover Removal {A]
1. Remove all screws [1] (see Figure "Rear view").
2. Remove the Lower Center Back Cover.
4.1.2
Upper Back Cover Removal (B)
1. Remove all screws [2] (see Figure "Rear view").
2. Lift the cover from pegs [3] and remove the cover.
4.1.3
Side Back Cover Removal
Remove all screws from each of the Side Back Covers (see
Figure "Side back covers").
Note: This allows access to the Side I/O Panel, or to the Left or
the Right Speaker.
EBJ1.0U
Mechanical Instructions
1 2
1 2
1 3
1 B
1 2
1 2
1 2
1 1
1 1
1 1
1 A
1 1
1 1
1 1
1 1
G_15860_058.eps
1 1
4.1.4
Lower Front Cover Removal
1. Remove all screws from each of the Side Back Covers (see
Figure "Side back covers").
1 2
2. Remove screws [1] (see Figures "Lower Front Cover").
3. Release catches [2] and remove the Lower Front Cover.
Note: This allows access to the Front Control Panel.
1 2
1 2
2
100406
To re-assemble:
1. Remove the two rubber plugs [3] from the centre of the
frame, and put them back on the pins [4] on the rear of the
Lower Front Cover.
2. Put the Front Cover back in its approximate position, push
the catches [2] in place, lift the Lower Front Cover as far as
possible, and position the pins by gently tapping on the
center of the cover.
1 1
1 1
1 1
Figure 4-2 Side back covers
1
Figure 4-3 Lower front cover 1/3
1 1
1 1
1 1
1 1
G_15860_059.eps
100406
G_15860_060.eps
100406
Advertisement
Table of Contents
