All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by WS 0571 TV Service...
Technical Specifications, Connections, and Chassis Overview EN 2 ES1E 1. Technical Specifications, Connections, and Chassis Overview Index of this chapter: Connection Overview 1.1 Technical Specifications 1.2 Connection Overview Note: The following connector colour abbreviations are used 1.3 Chassis Overview (acc. to DIN/IEC 757): Bk= Black, Bu= Blue, Gn= Green, Gy= Grey, Rd= Red, Wh= White, and Ye= Yellow.
Page 3
Technical Specifications, Connections, and Chassis Overview ES1E EN 3 EXT1: Video RGB - In, CVBS - In/Out, Audio - In/Out EXT2: Video YC - In, CVBS - In/Out, Audio - In/Out E_06532_001.eps E_06532_001.eps 050404 050404 Figure 1-3 SCART connector Figure 1-4 SCART connector - Audio R 0.5 V...
Safety Instructions, Warnings, and Notes EN 4 ES1E 2. Safety Instructions, Warnings, and Notes Index of this chapter: 2. Clean the power supply and deflection circuitry on the 2.1 Safety Instructions chassis. 2.2 Maintenance Instructions 3. Clean the picture tube panel and the neck of the picture 2.3 Warnings...
Page 5
Manufactured under license from Dolby Laboratories. 2.4.4 Lead-free Solder “Dolby”, “Pro Logic” and the “double-D symbol”, are trademarks of Dolby Laboratories. Philips CE is producing lead-free sets (PBF) from 1.1.2005 onwards. 2.4.2 Schematic Notes Identification: The bottom line of a type plate gives a 14-digit •...
Page 6
Caution: For BGA-ICs, you must use the correct temperature- profile, which is coupled to the 12NC. For an overview of these profiles, visit the website www.atyourservice.ce.philips.com (needs subscription, but is not available for all regions). You will find this and more technical information within the "Magazine", chapter "Repair Downloads".
Directions for Use ES1E EN 7 3. Directions for Use You can download this information from the following websites: http://www.philips.com/support http://www.p4c.philips.com...
Small Signal Board (SSB) of an backwards. N.B.: You do not need to pull the other two ES1E, A02, A10, or EMG (EMx) chassis, via two “IDE” locking handles backwards. cables to the SIMM connector in the set. In this way, you 2.
Page 9
Mechanical Instructions ES1E EN 9 4.4.1 Top Control Assy/Panel 1. Release the two fixation clamps (1) by pushing them upward. 2. At the same time, the complete assy must be pulled backward (2). 3. If the board has to be removed, release the two clamps at the sides of the bracket and lift the panel out (3).
(not the standby hours) in hexadecimal value. the Customer Service Mode (CSM) is used for communication • SW. Displays the date of the software and the software between a Philips Customer Care Centre (P3C) and a version of the ROM; customer. example: A2EU04-5.10 = AAABBC-X.YY.
Page 11
When a customer is having problems with his TV-set, he can After activating this mode, “SAM” will appear in the upper right call his dealer or the Philips helpdesk (P3C). The service corner of the screen. technician can than ask the customer to activate the CSM, in order to identify the status of the set.
5.4.1 Introduction line CONTRAST is low (< 10), increase them. ComPair (Computer Aided Repair) is a service tool for Philips Picture too Bright Consumer Electronics products. ComPair is a further 1. Press SMART PICTURE on the RC. In case the picture development on the European DST (service remote control), improves, decrease the “Brightness”...
Service Modes, Error Codes, and Fault Finding ES1E EN 13 entire error buffer. Diagnosis is done on I C level. ComPair When multiple errors occur (errors occurred within a short time can access the I C bus of the television. ComPair can send...
Page 14
Service Modes, Error Codes, and Fault Finding EN 14 ES1E Table 5-1 Error Table operation” mode and in “protection” mode). In order to avoid confusion with RC5 signal reception blinking, this LED blinking procedure is terminated when an RC5 Error Description command is received.
Block Diagrams, Testpoint Overviews, and Waveforms ES1E AA 6. Block Diagrams, Testpoint Overviews, and Waveforms Wiring Diagram DEGAUSSING COIL TOP CONTROL PANEL AQUADAG ROTATING 0215 CRT PANEL COIL (COMPONENT VIEW) 1361 1351 1382 FRONT WHITE SPEAKER L SPEAKER R INTERFACE...
Block Diagrams, Testpoint Overviews, and Waveforms ES1E AA Block Diagram 1 Audio & Video TUNER IF & SAW FILTER (1) Present for China only VIDEO SOURCE SELECT & DATA LINK VTUN (2) Present for AP-Multi, China & EU only 7100-B...
Circuit Diagrams and PWB Layouts ES1E AA SSB: Feature Box FEATURE BOX 7300 BACK END PROCESSING LUMINANCE SHARPNESS SHARPNESS MEASURE COLOUR FEATURES FILTERS COMPENSATION DYNAMIC COLOUR DELAY PEAKING SKIN BLUE GREEN FRAME PANORAMA TONE SPACE COMPENSATION STRETCH ENHANCE PROCESSING CONTROL...
Circuit Diagrams and PWB Layouts ES1E AA Top Control Panel (PV2) Personal Notes: 0215 A1 0216 E1 0217 D1 TOP CONTROL PANEL 1090 D2 1091 B2 1092 B3 1093 B4 1094 B4 1095 B4 TO 0215 3086 2010 A2 4091...
Page 70
Circuit Diagrams and PWB Layouts ES1E AA Layout Top Control Panel (PV2) (Top Side) Layout Top Control Panel (PV2) (Bottom Side) 0215 A1 2010 A1 0216 F1 2012 E1 0217 D1 2013 D1 1090 F1 2014 D1 1091 B1 2016 D1...
Alignments ES1E EN 81 8. Alignments Index of this chapter: 8.1 General Alignment Conditions 8.2 Hardware Alignments 8.3 Software Alignments 8.4 Option Settings 1502 General Alignment Conditions Warning 8.1.1 Default Alignment Settings All alignments are on hot-part ! 5430 Perform all electrical adjustments under the following conditions: •...
Page 82
Alignments EN 82 ES1E 8.2.2 Focus alignment – For "Negative modulation", on SCART pin 1 or 3 (audio out): Adjust IF-PLL OFFSET until the largest Signal Noise Ratio (SNR) is reached. The LOT has the following outline: – For "Positive modulation", on SCART pin 19 (video –...
Page 83
Alignments ES1E EN 83 Alignment 5. EW_3 (East-West parameter 3): Has effect on the length of the vertical E/W lines just below EW_2. 6. EW_4 (East-West parameter 4): Has effect on the length of VERT. SHIFT the vertical E/W lines just below EW_3.
Page 84
Alignments EN 84 ES1E Alignment • The new option setting is only active after the TV is Normally, no adjustments are needed. switched "off" and "on" again with the Mains switch (the If the white tone alignment values used in CSM of the the TV EAROM is then read again).
Page 86
. The following combinations are possible: DGSC: Digital Scan. 00 = Other tuner; Function: Enable/Disable the Digital Scan in the DIGITAL OPT 11 = Philips tuner (bit 4 and bit 3@ 1C = 1). menu. Values: OFF= Disabled, menu item DIG SCAN is not available.
Page 87
Alignments ES1E EN 87 Values: OFF= Disabled. Dual text is not available. ON= ATS: Automatic Tuning System. Enabled. Dual text is available (WS = 1; 4 : 3 = 0). Function: Disable/Enable automatic tuning system. Values: OFF= Disabled, automatic tuning system is ignored.
DEFLECTION DEFLECTION COIL The ES1E is a flat screen type CRT TV set for the year 2005 - 2006. It is based on the SSB of the A02, but the LSP, called 2 nd ORDER S-CORRECTION Esplanade, has been redesigned in order to reduce the “hot”...
Page 89
Circuit Descriptions, Abbreviation List, and IC Data Sheets ES1E EN 89 9.2.1 Basic Description. T1 - T2 Deflection T1-T2 T0 - T1 Vbatt Deflection T0-T1 Vbatt 5455 5455 HORIZONTAL DEFLECTION COIL HORIZONTAL DEFLECTION COIL Line transistor CONDUCTS Line transistor OPENS...
Page 90
Circuit Descriptions, Abbreviation List, and IC Data Sheets EN 90 ES1E T2 - T3 T3 - T4 Deflection T2-T3 Deflection T3-T4 Vbatt Vbatt 5455 5455 HORIZONTAL HORIZONTAL DEFLECTION DEFLECTION COIL COIL Line transistor OPEN Fly-back caps Diode DISCHARGE CONDUCTS DMV1500M...
Page 91
Circuit Descriptions, Abbreviation List, and IC Data Sheets ES1E EN 91 beginning of the start-up phase, the driver receives its +5V coil of the transformer charges the capacitor and this results in supply via 3421 and 6465 (see circuit diagram A2). During the a parabolic waveform.
Page 92
Circuit Descriptions, Abbreviation List, and IC Data Sheets EN 92 ES1E extra current generates a parabolic waveform across 2419 at damaged if the vertical scanning circuit is not working and all the centre scanning position. The parabolic waveform is the beam energy is concentrated on one spot of the CRT neck.
Circuit Descriptions, Abbreviation List, and IC Data Sheets ES1E EN 93 Abbreviation List Monochrome TV system. Sound carrier distance is 6.5 MHz. D= VHF- band, K= UHF-band 0/6/12 SCART switch control signal on A/V Digital to Analogue Converter board. 0 = loop through (AUX to TV), 6 Dynamic Astigmatism and Focusing;...
Page 94
Mega bits per second HEADPHONE-R Stereo headphone (Right) signal Multi Channel Sound: refers to Dolby output. Pro Logic Surround in ES1E ADOC Horizontal Flyback Pulse; Horizontal Mode control data output sync pulse from large signal deflection MIPS Microprocessor without Interlocked Head Phone Pipeline-Stages;...
Page 95
Circuit Descriptions, Abbreviation List, and IC Data Sheets ES1E EN 95 MUTE MUTE Line Radio Data System (European); This NAFTA North American Free Trade is an MPX signal carried in FM radio Association: Trade agreement channels (87.5 … 108 MHz)
Circuit Descriptions, Abbreviation List, and IC Data Sheets EN 96 ES1E SNDL-SC2-IN Sound left SCART2 in VGUARD Vertical guard voltage SNDL-SC2-OUT Sound left SCART2 out Video Intermediate Frequency SNDR-SC1-IN Sound right SCART1 in Variable Level out; Processed audio SNDR-SC1-OUT Sound right SCART1 out...