Troubleshooting - Philips AJ210/05 User Manual

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
stances should you try to repair the set yourself, as this will invalidate the warranty.
No sound.
– Volume not adjusted.
• Adjust the VOLUME.
Display error / no reaction to any
controls.
– Electrical malfunction
• Press RESET hole on the bottom of the set with a
ball pen.
Occasional crackling sound during FM
broadcast.
– Weak signal.
• Extend the pigtail antenna fully.
CAUTION
- High voltage! Do not open.You run the risk of getting an electric shock.
The machine does not contain any user-serviceable parts.
- Modification of the product could result in hazardous radiation of EMC or
other unsafe operation.
Do not open the set as there is a risk of electric shock. Under no circum-
The alarm does not function.
– Alarm time not set.
• See section on Setting alarm time.
– Alarm mode not selected.
• See section on Setting alarm mode.
Volume too low for radio.
• Increase the volume.