Step 12. Hood Installation; Finishing Requirements - Lennox Merit Plus Series Installation Instructions Manual

LENNOX HEARTH PRODUCTS • MERIT PLUS

Step 12. HOOD INSTALLATION

All models must have hoods installed prior
to operating.
Slide the hood into the slots on the lower edge of
the radiant panel (Figure 62).

FINISHING REQUIREMENTS

Wall Details
Complete finished interior wall. To install the
appliance facing flush with the finished wall,
position framework to accommodate the thick-
ness of the finished wall (Figure 62).
See Page 5 for
Cold Climate Insulation and
Page 8 for Clearances.
34
DIRECT VENT GAS FIREPLACES (MPDP35/40) • INSTALLATION INSTRUCTIONS
®
Combustible
Finished Wall
This area must remain
Materials
clear of combustible
materials.
Combustible
materials NOT
allowed below
Drywall Backstop
this point on
(bent up for
appliance face.
1/2" or 5/8")
Top Standoff
4"
(100 mm)
Top of Appliance
Radiant panel
Top of Door Frame
Hood must be installed as shown.
Figure 62
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Min. 1"
(25 mm)