Installing Sicalis Pmc; Installing Windows Nt 4.0 Service Pack 5 - Siemens SIMATIC HMI SICALIS PMC 7 Equipment Manual

2.3

Installing SICALIS PMC 7

Installation Steps
The installation of the operator panel is comprised of the following steps:
1. Install Windows NT 4.0 Service Pack 5 (page 2-9)
2. Install the SICALIS PMC 7 runtime software (page 2-11)
3. Install the PROFIBUS IM 182 interface module and driver software (page 2-14)
4. Install user application (page 2-15)
Note
Before the installation, connect a PS/2-compatible keyboard and mouse to the
operator panel.
The description of the dialogs assumes a working knowledge of Windows.
2.3.1

Installing Windows NT 4.0 Service Pack 5

Setup
When the device switched on the first time, it runs Windows NT with Service Pack
1 and guides you through the setup. The following dialogs are displayed in VGA
mode.
1. The window with Software License Agreement appears. Click on the I Agree
button to indicate your acceptance of the conditions.
2. Click on Next to close the Windows NT Workstation Setup welcome window.
3. In the Registration dialog, enter the Product ID from the Certificate of
Authenticity. Click on Next. You will find the certificate with the Product ID in the
included Windows NT software package.
4. In the Administrator Account field, login as Administrator with the password
simatico and then confirm this. Click on Next. In the later operation, you will
only need to enter the password once. After the installation is completed, the
system will perform the logon automatically during startup.
5. Acknowledge the Ready messageby clicking on Next. Windows NT Workstation
with Service Pack 5 will now be automatically configured on your computer.
Afterwards, start the system again with Restart Computer.
SICALIS PMC 7 Operator Panel Equipment Manual
Release 09/00
Installation
2-9