Advanced Programming; Basic Programming Parameters (5 - Cycle Softener System) - Pentair AUTOTROL MAGNUM 742 Installer Manual

6.4.

Advanced programming

Note
Press and hold
displayed on the bottom left of screen.

6.4.1. Basic programming parameters (5 - Cycle softener system)

Parameter description
P1 Time of day
P2 Day of week
Time of
P3
regeneration
P4 Calendar override 0 - 99
Day of week
P5
regeneration
P6 Salt setting
P7 Capacity of unit
P8 Hardness of water 30 - 2000
* Calculated depending on salt setting and resin volume. The capacity may be manually adjusted.
Ref. MKT-IM-012 / C - 25.10.2019
+ for 5 seconds to access advance programming. A "P" symbol is
Default
Range of values
value
1:00 - 12:59 AM
12:00 PM
0:00 - 23:59 PM
N/A None
1:00 - 12:59AM
2:00 AM
0:00 - 23:59PM
3
N/A None
50 - 290 110
0.1 - 90 *
400
Installer Manual Magnum 742-762 - Programming
Units of
measure
Hour : Range depends on value
minute selected for P10.
N/A -
Hour : Range depends on value
minute selected for P10.
0 = no calendar override.
0.5 = regeneration twice a day
at time of regeneration and 12
Days hours later.
Calendar override skipped if at
least one day of regeneration
selected.
Day of week regeneration is
skipped if calendar override is
N/A
more than 0 (742 controller
only).
Unit of measure depends on
g/l
value selected for P9.
Unit of measure depends on
kg
value selected for P9.
Unit of measure depends on
g/l value selected for P9 (762
controller only).
Notes
55 / 106