Washing Programme - Whirlpool AWM 5500 Manual

3gb10006.fm5 Page 24 Tuesday, May 15, 2001 3:21 PM

WASHING PROGRAMME

Selecting the programme:
1.Plug in the appliance.
2.Turn on the water supply tap.
3.Set the Programme Selector knob to the desired programme.
4.Depending on model, set the Temperature Selector knob to the desired temperature.
5.Depending on model, set the Spin Speed Selector knob to the desired spin speed.
6.Select additional options, if desired, pressing the corresponding button.
By a further pressing of the button this option can be turned off again.
7.Check that the door is well closed. Press the "On/Off" button.
The indicator light will come on (if it is present - depending on the model).
Door lock
The door locks automatically after the programme start until the end of the programme.
If the programme selector is moved to the "Stop" position or if the electricity supply is interrupted,
then after approximately one minute the door is released.
In case of interrupted electricity do not open the door, because hot water could be released from the
appliance.
Programme end
The programme selector knob is at the stop position.
1.Press the "On/Off" button. The indicator light turns off.
2.Cancel the special options by pressing the appropriate buttons.
3.Turn the water supply tap off.
4.Wait for the door to unlock (about one minute).
5.Open the door and unload the machine.
N.B. Do not fully close the door but leave it ajar to allow the drum to dry out.
Changing programme
1.Press the "On/Off" button. The indicator lights turns off.
2.Select the new programme.
3.Press the "On/Off" button. The new program will re-start.
For this programme do not add any further detergent.
Changing options
The options can be selected or deselected without switching off the appliance.
Programme interruption or pause
To interrupt the running programme for a certain period and continue it at a later time:
1.Press the "On/Off" button.
2.Following the desired pause press the "On/Off" button once again.
Cancelling the programme
If the current programme is to be terminated prematurely and cancelled, the water must be pumped out
first before the door can be opened:
1.Press the "On/Off" button to switch off the appliance.
2.Set the programme selector to programme setting "Drain".
3.Press the "On/Off" button in order to start the "Drain" programme.
24