Cateye Padrone Smart Quick Setup Manual
Hide thumbs
Also See for Padrone Smart:
- User manual (11 pages) ,
- Quick start (2 pages) ,
- Quick start (2 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Cateye Padrone Smart
Summary of Contents for Cateye Padrone Smart
- Page 1 Strada Smart/ Padrone Smart Quick Set-up Guide...
- Page 2 1. Format the smart computer B. The computer will enter the smartphone A. While holding the menu bu<on, press and pairing screen following the formaDng release the AC bu<on, and then release the operaEon. menu bu<on.
- Page 3 2. Launch the Cateye Cycling App A. Open the Cateye Cycling app on your iPhone or Android device. Press the menu bu<on on the upper leI hand corner of the screen and turn connect ON. B. Click on ‘Se:ngs’ and enable Bluetooth on your smartphone.
- Page 4 3. Pair smart computer to the Cateye Cycling App B. Click on ‘pairing’ to connect the smart computer A. From the menu screen in the app, click on device, to the Cateye Cycling App. The smart computer and then press the blue ‘Pair to Device’ bu<on at will appear in the device screen with a blue the bo<om of the screen. check-mark once it is connected to the app.
- Page 5 4. Configure the units of measurement A. Return to the main menu screen by B. Click on ‘units’ and select the desired units of measurement. pressing and click on ‘General’ under the SeDng tab.
- Page 6 5. Pair and configure the sensors D. Scroll up or down with your finger to select the A. Return to the device pairing screen , , Ere circumference value when an ISC-12 device and press the blue “pair to device” sensor is paired with the Cateye Cycling App. bu<on. B. Pass a magnet across the sensor, wear the HR monitor, or rotate the cranks to trip the sensor(s). C. Click “pairing” to pair the sensor(s).
- Page 7 6. StarGng a ride (from the app) B. Press the recording bu<on at the bo<om of the A. Return to the main menu screen by pressing trip screen to begin recording a ride. The screen [ , and then press the ‘Trip’ bu<on above will change to say ‘recording’ once a ride is in the acEvity tab. progress.
- Page 8 7. StarGng a ride (from the smart computer) B. The screen state will change from ‘ready’ to A. Following step 5, press and hold the mode display the ride data once a ride has been bu<on, or press and hold the lower face of the started. smart computer (3 raised dots) for 2 seconds to begin recording a ride.