Laser And Led Safety; Fcc Class A Compliance - Cisco PA-POS-2OC3 Installation And Configuration Manual

FCC Class A Compliance

Laser and LED Safety

The multimode aperture has a Class 1 laser warning label, as shown in
Figure 2-1
CLASS 1 LASER PRODUCT
Class 1 laser product. Statement 1025
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 1051
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case users will be
required to correct the interference at their own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
•
•
•
•
This product has been designed to meet these requirements. Modifications to this product that are not
Caution
authorized by Cisco Systems, Inc. could void the various approvals and negate your authority to operate
the product.
PA-POS-2OC3 Two-Port Packet-over-SONET Port Adapter Installation and Configuration
2-12
Class 1 Laser Product Warning Label on the Cisco PA-POS-2OC3 Adapter Card
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
Move the equipment farther away from the television or radio.
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,
make certain the equipment and the television or radio are on circuits controlled by different circuit
breakers or fuses.)
Chapter 2 Preparing for Installation
Figure 2-1.
OL-3028-06