Electrolux EB4SL40SP User Manual page 36

36 www.electrolux.com
Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The display prompts to set
the Language.
The display prompts to set
the Language.
The display shows F111.
The display shows an error
code that is not in this ta‐
ble.
Steam and condensation
settle on the food and in
the cavity of the oven.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
Possible cause
The automatic switch-off is
activated.
The door is not closed cor‐
rectly.
The fuse is blown.
The lamp is defective.
There was a power cut lon‐
ger than 3 days.
The demo mode is activa‐
ted.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the
oven for too long.
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
Remedy
Refer to "Automatic switch-
off".
Fully close the door.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Refer to "Before first use"
chapter.
Turn off demo mode in:
Menu / Basic Settings /
DEMO. Activation / deacti‐
vation code: 2468.
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.