Basic Functions; Replacing Battery (Lithium Cr2032) Into The Remote Control - Philips MCM108/98 User Manual

Preparations
C
Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", the wire (marked red) to
"+" and the wire (marked black) to "-".
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of + / - speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example CD, TUNER).
3
Then select the desired function (for example
É, í, ë).
Replacing battery (lithium
CR2032) into the remote
control
1
A
Pull out the knob slightly to the left.
2
B
Pull out the battery compartment .
3
Replace a new battery and fully insert the
battery compartment back to the original
position.
A
B
CAUTION!
Batteries contain chemical substances, so
they should be disposed off properly.

Basic Functions

STANDBY-ON SOURCE BAND PROG/CLOCK
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
Press STANDBY-ON (y on the remote
control).
The system will switch to the last selected
source.
Press SOURCE (CD, TUNER or AUX on
the remote control).
The system will switch to the selected
source.
To switch the system to standby mode
Press STANDBY-ON (y on the remote
control).
The clock is displayed.
Power-saving automatic standby
The power-saving feature automatically switches
to standby 15 minutes after a CD playback has
ended and no control is operated.
5
Adjusting volume and sound
1
Press VOLUME – /
volume.
Display shows the volume level
number from 0-32.
2
Press DSC repeatedly to
select the desired sound effect:
JAZZ / POP / CLASSIC /
ROCK.
3
- +
VOLUME TUNING
Press DBB (on the remote control) to switch
bass enhancement on or off.
Display shows:
DBB
4
Press MUTE on the remote control to stop
sound play-back instantly.
Playback will continue without sound and
the display shows MUTE .
To start sound playback you can:
– press MUTE again;
– adjust the volume controls;
– change source.
+ to increase or decrease
and a
VOLUME
DBB DSC
if the DBB is activated.
6