Table of Contents
Advertisement
User's Guide
Use only the USB cable that came with your device and avoid abrasions, cuts,
fraying, crimping, and kinking. Using any other USB cable could cause fire, electrical
shock, or injury.
Do not store the cables in the following locations:
Outdoors
Near excessive dirt or dust, water, or heat sources
In locations subject to shocks, vibrations, high temperature or humidity, direct
sunlight, strong light sources, or rapid changes in temperature or humidity
Keep the supplied USB cable, etc., in a location that is out of reach of children to
avoid the risk of injury.
Please put the packaging materials such as the supplied plastic bags in a place that
children cannot obtain or discard them to avoid the risk of suffocation.
Caution
If you are not using the device for a long time, remove the USB cable from the
connector.
This product has a power-saving mode and a standby mode. The zero-energy state
can be achieved only when the product is connected without any external input
power.
At least every year, please disconnect the power cord from the wall outlet to check
whether the power cord is exposed, damaged, cracked, dent, hot, pin deformation
or any burnt marks. If these conditions exist, please do not use the power cord
again and contact the authorized service personnel or dealer.
Make sure the power cord is plugged into a grounded electrical outlet, otherwise it
may cause a fire or electric shock.
Be sure to fully plug the power cord into a wall outlet. Failure to completely insert
may cause unstable connections and heat build-up, creating an unsafe condition.
When disconnecting the power cord from the wall outlet, be sure to pull the plug,
not the power cord, as this may damage the power cord and cause a fire or electric
shock.
To repair the machine, be sure to disconnect the power cord from the wall outlet.
Make sure the power cord is firmly secure and will not trip over.
SAFETY INSTRUCTION
This printer is a page printer which is operated by means of a LSU (Laser Scanning Unit). There is
no possibility of danger from the LSU, provided the printer is operated according to the
instructions in this manual. Since radiation emitted by the laser beam is completely confined
within protective housings and external covers, the laser beams cannot escape from the machine
during any phase of user operation.
viii
Advertisement
Table of Contents
