Fcc Part 68 Statement; Connection To The Telephone Line - Comtech EF Data NetPerformer SDM-9 Series Hardware Installation Manual

SDM-9XXX Series Hardware Installation Guide
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

FCC Part 68 Statement

The SDM-9220 and the SDM-9230 comply with Part 68 of the FCC rules and the
requirement adopted by ACTA of the United States.
On the product nameplate of this equipment (located on the underside of the product
chassis) is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX.
If requested, this number must be provided to the telephone company.

Connection to the Telephone Line

B-10
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• This equipment uses jacks for connection to the telephone line. You must, upon,
request, provide the following "USOC Jack type" to your local telephone com-
pany:
- For equipment equipped with the interface card 100-1107-003/004, the
USOC jack type: RJ11C
- For equipment equipped with the interface card 100-1111-001/002, the USOC
jack type: RJ48C
• This equipment cannot be used on the public coin phone service provided by the
telephone company. Connection to party line service is subject to state tariffs.
• Your telephone company may discontinue your service if your equipment causes
harm to the telephone network. They will notify you in advance of disconnection,
if possible. During notification, you will be informed of your right to file a com-
plaint to the FCC.
• Occasionally, your telephone company may make changes in its facilities, equip-
ment, operation, or procedures that could affect the operation of your equipment.
If so, you will be given advance notice of the change to give you an opportunity
to maintain uninterrupted service.
• THE REGISTRATION NUMBER OF THE SYSTEM MUST BE PROVIDED
SO THAT THE TELEPHONE COMPANY CAN ASCERTAIN INTENDED
MODES OF OPERATION AND VERIFICATION OF REGISTRATION
PORTS.
Memotec Inc.