Toyotomi SmartCube User Manual page 32

Multifunctional Unit 5 in 1
Manual drainage:
1.1 When either the internal or the external water tank is full the unit will stop working.
1.2 Shut off the unit and unplug. Remove the rubber water stopper and leave the internal tank
to drain in the external tank for at least 30 minute. Try not to move the model abruptly as
this may cause water to spill out from internal water tank.
1.3 Empty the external tank
1.4 Put the rubber water stopper back (or not if using next in dehumidifi er mode).
Continuous drainage:
1.1 Remove the rubber water stopper (do not remove the water tank).
1.2 Use a water pipe to connect to the water outlet.
1.3 You can plumb this pipe into your current plumbing system, lead it outside or use it in a
conjunction with a water pump (e.g. cellar use).
1.4 This mode is recommended for dehumidifi er mode continuous unattended operation.
Notes: When the unit is in the air conditioner mode, it is recommended not to have the water
drain pipe installed. Please make sure that the rubber water stopper is in place when the unit
is running.
Please remove the air exhaust hose, connect a drain hose to the drain hole and lead the water
to the outside in order to intensify dehumidifying capacity.
※ When the water tanks are full, «E4» will be displayed on the display panel. Please remove the
rubber water stopper of the drain port to drain out the internal tank fi rst than the external one.
After the tanks are empty, please restart the unit and then the unit can operate normally.
Maintenance
Cleaning
Please shut off the unit and unplug from the mains before cleaning or performing any maintenance
Clean the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage.
Air fi lter cleaning
a) Clean the air fi lters at least every 2 weeks. If the air fi lters are blocked with dust, the unit's
performance will be signifi cantly affected.
b) Pull out both side mesh fi lters and gently wash them by immersing them in warm (about
40℃) water with a neutral detergent.
c) Rinse it and then dry it thoroughly
d) Vacuum clean gently the optional HEPA fi lters. Never wash them.
e) Carefully re-install air fi lters
End of Season Maintenance
1. Disconnect from main power.
2. Pull out the plug from the drainage hole and empty the internal tank. You can also drain the
water by leaning the unit toward the water tank.
3. Empty the external tank
4. Then plug back and switch the unit to low fan mode in air cleaning mode.
32
GB