Toyotomi SmartCube User Manual page 29

Multifunctional Unit 5 in 1
it as water may still defrost into the tank. Do not move the unit once the tank is displaced and
ensure rubber stopper in place to prevent water leaks. To resume operation insert the tank back
and press power button.
Note: When in dehumidifi er mode remove the rubber water stopper (14) from drain. Water will
go in to the water tank (15). Permanent drainage and water pump can be attached to the unit
for unattended use. Occasionally the DF may appear on the LCD. The dehumidifi er is in defrost
mode and normal operation will resume as soon as the defrost cycle fi nishes. The lower the
room temperature the more defrosting will happen.
HUMIDIFIER MODE
Select the humidifi er mode from function button. The multifunctional air treatment unit is a
powerful 5 litres per day humidifi er.
If your room is too dry or suffering from allergies, your multifunctional air treatment unit will help
maintaining the exact humidity level you need.
The multifunctional air treatment unit intelligent micro-computer will measure the exact humidity
in the room and only add enough moisture to achieve the set humidity.
Initially add approximately a liter of water via water fi lling port (13) behind the fi lter. Set the
humidity from HUM- / HUM+ keys.
Unit will stop after about 4 hours. You will need to add more water if necessary (approx. 0.8
litres). Any excess water will go in the main water tank (15).
Fan and the water spray motor will work but the compressor will be turned off in this mode.
Note: When in humidifi er mode make sure the rubber water stopper (14) is in place otherwise
unit will not humidify.
HUMIDITY SETTINGS (HUM-, HUM+)
CO(continuous) 30% 35% 40% 45% 50% 55% 60% 65% 70% 75% 80%
85% 90% CO
AIR PURIFIER / FAN MODE
Select the Air Purifi er mode from function button. Your multifunctional air treatment unit is a dual
HEPA air purifi er and will improve the indoor air quality.
During normal air cleaning operation the LCD will show
operates. If used without the optional HEPA fi lters the unit will operate in fan mode only.
After 2000 hours of fan operation, the Alarm indicator will fl ash displaying E8 error.
Laundry mod: Set the humidistat to continuous mode or set
the range from 30%-50% and fan speed to maximum and place
within 1.5 meters from clothes / laundry dryer. Do not place
clothes directly over any of the unit's vents.
You can also install the hot air exhaust hose and direct it to the
spot you want to rapidly dry (e.g. plaster, clothes, shoes, etc.).
Make sure that there is nothing blocking the hot air exhaust air
fl ow.
On tank full the dehumidifi er will stop operating. Do not remove
the water tank before is full and the dehumidifi er stops operating.
Once the tank is full wait for another 30 minutes before removing
29
symbol and only the fan motor
GB