Intrusion Options - Tamper Switch Alarms - Siemens MT8001 MP4.20 Installation Function & Configuration Commissioning Safety Regulations

5.4.2.4 Intrusion options – Tamper Switch Alarms
Building Technologies
Fire Safety & Security Products
Configure the Approvals-4 tab (see Fig. 41) to define a Tamper Switch Alarm on
the MT8001.
To configure Tamper Switch Alarm, do the following:
1. Check the Tamper Switch Alarm transmission to enable a Tamper Switch
Alarm on the MT8001.
2. Drag and drop the appropriate node from the Composer tree to the Approvals-4
tab window.
Note: Typically, the node will be a point on an intrusion panel.
3. In the Drop Point dialog box, do the following:
a. Choose a property from the Property drop-down list.
b. Choose a command from the Command drop-down list.
c. Change the timeout (command feedback), if desired.
4. Select Add.
Note: To update the list in the Drag and Drop window, select the node, and then
select Change or Remove.
Fig. 41 Approvals-4 tab
048_DMS_MT8001_ICC_MP4.20_A6V10096181_a_en.doc
Configuring the MT8001
43
06.2009