Using The Hydraulic System Test Ports - Toro Reelmaster 5610 Owner's/Operator's Manual

Figure 70
1. Hydraulic filter
Figure 71
1. Hydraulic filter
3. Remove the filter.
4. Lubricate the gasket on the new filter with
hydraulic fluid.
5. Ensure that the filter mounting area is clean.
6. Install the filter by hand until the gasket contacts
the mounting surface, then rotate it an additional
1/2 turn.
7. Repeat the procedure on the other filter.
8. Start the engine and let it run for about 2 minutes
to purge air from the system.
9. Shut off the engine and check for leaks.
Using the Hydraulic System
Test Ports
Use the hydraulic system test ports to test the
pressure in the hydraulic circuits. Contact your local
Toro distributor for assistance.
Use the test ports on the front hydraulic tubes
72) to assist in troubleshooting the traction circuit.
g003980
1. Traction-circuit-test port
Use the test ports on the mow manifold block
73) to assist in troubleshooting the mow circuit.
g004150
49
Figure 72
(Figure
g031993
(Figure