Network Setup - Philips MBD3000/12 User Manual

4
Select an option, and press OK.
5
Select a setting, and press OK.
• To return to the previous menu,
press BACK.
• To exit the menu, press
[Night Mode]
Increase a soft sound level such as dialogue to
make it easier to hear at a low volume, while
simultaneously decreasing a loud sound level.
• [Auto] - Detect and select a best sound
level at a low volume. Applicable to tracks
with Dolby TrueHD audio only.
• [On] – For quiet viewing at night.
• [Off] – For surround sound with a full
dynamic range.
Note
•
Applicable only to Dolby encoded DVD-video
or BD-video.
[Neo 6]
A post processing by DTS to generate a
surround sound effect from 2 channel audio.
• [Cinema] – Enable Neo 6 post processing
to the cinema mode.
• [Music] - Enable Neo 6 post processing
to the music mode.
• [Off] – Disable Neo 6 post processing.
[HDMI Audio]
Select an HDMI audio output when you
connect this product and the TV/audio device
with an HDMI cable.
• [Bitstream] – If the connected HDMI
device supports the appropriate HD
audio decoder, the original audio format
on the disc is sent. Otherwise, LPCM is
sent.
• [Auto] – Detect and select the best
supported audio format automatically.
[Digital Audio]
Select an audio format for the sound output
from the DIGITAL OUT jack (coaxial/optical).
• [Auto] - Detect and select the best
supported audio format automatically.
28 EN
•
•
.
•
•
[PCM Downsampling]
Set the sampling rate for PCM audio output
from the DIGITAL OUT jack (coaxial/optical).
•
•

Network setup

1
2
3
Video
Audio
Network
EasyLink
Preference
Advanced
4
5
[PCM] - The audio device does not
support multi-channel format. Audio is
downmixed to two-channel sound.
[Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-
video special sound effect is disabled).
Note
Ensure that the audio format is supported
by the disc and the connected audio device
(amplifier/receiver).
When [Bitstream] is selected, interactive
audio like button sound is muted.
[On] - PCM audio is down-sampled at
48kHz.
[Off] - For BD or DVD recorded in
LPCM without copyright protection,
two-channel audio signals up to 96 kHz
are output as LPCM signals with no
conversion.
Press .
Select [Setup], and press OK.
Select [Network], and press .
Network Installation
View Network Settings
View Wireless Settings
Select an option, then press OK.
Select a setting, then press OK.
• To return to the previous menu,
press BACK.
• To exit the menu, press .