Case Cleaning; Connection - Fagor VTP Series User Manual

1.1 CASE CLEANING

When you have your display case well located, you must clean it.
The first cleaning must be made with water and a neutral washing up liquid. When cleaned and dry , put the
accessories in the right place.
The cleaning of the external part of the equipment must be made daily with a dampened clean cloth. You cannot
use any abrasive substance or with any chlorine.

1.2 Connection

GENERAL
Before plug in the refrigerated display case, check that the voltage and frequency of the electric
power are the same of the ones pointed out in the features of the equipment.
BE CARREFUL , THE ELECTRICAL SYSTEM TO CONNECT THE DISPLAY CASE MUST HAVE A
GROUNDED SOCKET, AS WELL AS THERMOMAGNETIC PROTECTION AND DIFFERENTIAL
BREAKER.
Check that the wire section is available for the required electrical consumption.
The socket must be likely Schuko´s one cause the cable sleeve of your display case is from this
brand, (also known as F type or CEE 7/4"), with terminals of 4,8mm and grounded socket.
It´s forbidden to extend this cable sleeve for security reasons.
No insert anything through the fan grille or the area of the fridge equipment.
The place to put the unit must be on level and firm.
When starting the display, please get sure that there is not any heat source closer.
For correct operation of all the fridge equipments components it's very important having the air
intake free of any blockage.
No put the equipment in the open air.
You will find enclose the display cases table consumption to check the protection.
REFRIGERATED
DISPLAY
VTP-139
VTP-175
VTP-139-R
VTP-175-R
VTP-139-S
VTP-175-S
A: REGULATION SCREW
Turning to the right to go down the display case.
Turning to the left to go up.
VOLTAGE INTENSITY
230V 50 Hz
230V 50 Hz
230V 50 Hz
230V 50 Hz
230V 50Hz
230V 50Hz
CONSUMPTIO
(A) N
(W)
1.5 345
1.6 368
1.5 345
1.6 368
1.5 345
1.6 368
FUSES
(GL o AM) RESIDUAL
CURRENT
2 30mA
2 30mA
2 30mA
2 30mA
2 30mA
2 30mA
9