Grizzly G0824 Owner's Manual page 38

Using Quill
1.
Rotate quill lock lever counterclockwise to
loosen quill.
2.
Turn quill handwheel clockwise to move quill
toward spindle or counterclockwise to move it
away from spindle.
3.
Rotate quill lock lever clockwise to secure
quill.
Installing Tooling
This tailstock uses a quill with an MT#3 taper that
has a lock slot in the back of the bore that accepts
tang arbors and drill bits (see the Figures below
for examples).
Solid
Open
Solid
End
End
End
Figure 40. Types of tapered arbors and tooling.
Tang
Figure 41. Example photos of inserting tools
with tangs into the tailstock.
-36-
Tang
Screw
End
However, other tooling without tangs, such as
the four remaining tools shown previously, can
still be used if the potential load will not exceed
the strength of the tapered fit. For example, this
includes smaller drill chucks, drill bits, and centers.
Note: If the tooling has an open hole in the end
but is too short to be exposed in the drift slot for
removal, then a screw can be threaded into the
end of the tool to provide a solid surface for the
quill pin to push against when the quill is retracted
for tool removal. Otherwise, removal of such tool-
ing may be difficult.
To install and use tooling in tailstock:
1.
With tailstock locked in place, unlock quill,
then use handwheel to extend it approxi-
mately 1".
2.
Thoroughly clean and dry tapered mating
surfaces of quill and center, making sure that
no lint or oil remain on tapers.
Note: If tapered tool shaft has a tang, align
it with slot in back of quill before seating it.
3.
With a firm and quick motion, insert tool into
quill. Check to see if it is firmly seated by
attempting to twist it—a firmly seated tool will
not twist.
4.
Unlock tailstock and move it until tip of tool
is close to, but not touching workpiece, then
relock tailstock.
5.
Start spindle rotation, unlock quill lock lever,
then turn quill handwheel clockwise to feed
tool into workpiece.
Model G0824 (Mfd. Since 12/16)