Combination Switch - Mercedes-Benz 260 E 124 1987 Owner's Manual

Combination Switch

1 Low beam (with exterior lamp
switch turned to position 2)
2 High beam (with exterior lamp
switch turned to position 2)
3 High beam flasher (high beam
available independent of exterior
lamp switch position)
4 Turn signals, right
5 Turn signals, left
To operate the turn signals, move the
combination switch past the point of
resistance (up or down). The switch is
automatically cancelled when the
steering wheel is returned through a
large enough angle.
To signal minor directional changes of
the vehicle, such as changing lanes
on a highway, move combination
switch to the point of resistance only
and hold it there.
6 Control for
• windshield washer system
• headlamp cleaning system
(will work only with exterior
lamp switch in position 1 or 2)
When the washer system is acti­
vated, the wipers also operate for
a limited time.
The windshield washer nozzles
are automatically heated.
7 Windshield wiper control
0 Windshield wiper switched off
1 Intermittent wiping
II Normal wiper speed
III Fast wiper speed
Note:
If one of the turn signals fails, the turn
signal indicator system flashes and
sounds at a faster rate than normally.
In addition, the lamp failure indicator
will come on.