Mercedes-Benz 300D 2.5 1990 Owner's Manual page 87

Replacing bulbs:
Bulb for turn signal, parking, side
marker and standing lamp
(21/5 W/32/3 cp):
Compress retaining clip (4) and
remove housing towards the front.
Turn bulb socket (7) with bulb coun­
terclockwise and pull out. Push bulb
into socket, turn counterclockwise
and remove.
Bulb for high and low beam
(Halogen type 9004):
Compress cover (5) at the top and
remove upwards. Pull off electrical
connector (8). Turn clamping ring (9)
counterclockwise and pull out bulb
together with clamping ring. Remove
bulb.
Insert new bulb (flat side facing up),
mount clamping ring (9) (with tab
facing down) and turn clockwise. Push
electrical connector on securely.
Fog lamp bulb (Halogen type H3):
Compress the retaining clip of the
cover (6) at the top while removing it
upwards. Pull off electrical connector
(11). Disengage retaining clip and
remove bulb (10). When replacing
cover (6), make sure it clicks into
place.
Taillamp Assemblies
1 Turn signal lamp
(21 W/32 cp bulb)
2
Backup lamp
(21 W/32 cp bulb)
3 Side marker lamp
(1 0 W /6 cp bulb)
4
Stop lamp
(21 W/32 cp bulb)
5 Tail, parking and standing lamp
(10 W/6 cp bulb)
Turn the taillamp bulb carrier lock in
the trunk all the way to the left and
remove bulb carrier. To replace a
bulb, push bulb in, turn to the left and
remove.
I
85