Table of Contents
Advertisement
Screenshots
•
Use the Limits & On/Off tab
– V
(Vout_Command)
ref
– OC Fault and OC Warn
– OT Fault and OT Warn (Die Temperature)
– Power Good Limits
– Fault response
– UVLO
– On/Off Config
– Soft Start time (Turn On Rise)
– Margin voltage
After making changes to one or more configurable parameters, the changes can be committed to
nonvolatile memory by clicking Store DefaultAll. This action prompts a confirm selection pop-up, and if
confirmed, the changes are committed to nonvolatile memory to store all the modifications in non-volatile
memory.
Both the loop master device and the loop slave device are tied to same bus interface, a scroll-down menu
in the upper right corner can be used to switch view screens from one to the other. In two phase stacking
system, most configurable parameters are disabled in GUI if the device is detected as loop slave.
Figure
33.
34
Using the Stacking TPS546C23 Two Phase Evaluation Module
Figure 28
to configure the following:
Copyright © 2016, Texas Instruments Incorporated
www.ti.com
SLUUBH5 – November 2016
Submit Documentation Feedback
Advertisement
Table of Contents
