Loading The Configuration File In The Switch - Siemens SCALANCE XC-200 Set Up And Configuration

3 Configuration and commissioning of the Service Bridge
3.4

Loading the configuration file in the Switch

To facilitate the configuration of the Service Bridge, a pre-set configuration file is
provided for download on the article page of this Application Example. By loading
this configuration file, the switch acquires the settings described in Section
thus the basic functionality of the Service Bridge. Subsequently, system-specific
adjustments have to be made by hand – see Section 3.5.
If you have already configured the Service Bridge and replaced the switch (in the
case of a parts replacement, for instance), you can restore the configuration with
the self-generated configuration File. The plant-specific adaptations are already
included in it.
Note
You can download the pre-set configuration file at the following link:
https://support.industry.siemens.com/cs/ww/en/view/109747975
The configuration of the Service Bridge is loaded to the Switch via Web Based
Management (WBM).
The WBM can only be accessed via HTTPS after loading the configuration
because HTTP access is disabled. For this reason we recommend using HTTP to
connect before loading the configuration file.
Access via HTTPS
To access the WBM via HTTPS, enter the IP address in the browser, placing
"https://" before it.
For example:
7. Start Web Based Management via HTTPS in your browser (1).
8. Confirm the certificate warning that appears (2). The certificate warning is
shown because the default HTTPS certificate is not trusted.
1
2
Service Bridge – Setup and Configuration
Entry ID: 109747975, V1.4,
https://172.100.111.202/
05/2019
4 and
21