3.4.7
Optional breakout board for connector X5
An optional screw connection fitting is available should you wish to purchase a break-out board. The
break-out board, often referred to as a 'card', mounts on a 35mm DIN rail. The board has two-part
screw terminals for all of the digital inputs, digital outputs, analog inputs and analog outputs of the
MintDrive's X5 connector, together with indicator LEDs.
The catalog number for the breakout board is OPT017-501. A 2m (6ft) cable is available with correctly
shielded cables (catalog number CBL022-501).
3.4.8
CAN peripherals
If you wish to make connections to a CAN network see Appendix B, before continuing with section 4.
You should read the following sections in sequence before
48
Figure 27 - Optional breakout board
This completes the input/output wiring.
attempting to start the MintDrive.