Optional Remote Keypad Installation - Baldor ID15J1F50-ER Installation And Operating Manual

Optional Remote Keypad Installation

Note: Requires phone jack connector on the control board. Some models may not
have a phone jack installed. If the phone jack is not installed and you wish to
connect a remote keypad, contact Baldor.
A separate keypad may be remotely mounted using an optional Baldor
keypad extension cable (in addition to the keypad within the control). Keypad
assembly (CBLSM015KP - 5 ft, CBLSM046KP - 15 ft or CBLSM091KP - 30 ft)
comes complete with the extension cable and gasket required to mount it to
an enclosure. When the keypad is properly mounted to a NEMA Type 4X
indoor enclosure, it retains the Type 4X indoor rating.
Tools Required:
•
•
•
•
•
•
•
Mounting Instruction: For tapped mounting holes
1.
2.
3.
4.
5.
6.
7.
8.
9.
3-2 Receiving and Installation
Center punch, tap handle, screwdrivers (Phillips and straight) and
crescent wrench.
8-32 tap and #29 drill bit (for tapped mounting holes) or #19 drill
(for clearance mounting holes).
" standard knockout punch (1-
1- 1 /
4
RTV sealant.
(4) 8-32 nuts and lock washers.
Extended 8-32 screws (socket fillister) are required if the mounting
surface is thicker than 12 gauge and is not tapped (clearance mounting
holes).
Remote keypad mounting template. A tear out copy is provided at the
end of this manual for your convenience. (Photo copy or tear out.)
Locate a flat 4" wide x 5.5" minimum height mounting surface. Material
should have sufficient thickness (14 gauge minimum).
Place the template on the mounting surface or mark the holes as shown.
Accurately center punch the 4 mounting holes (marked A) and the large
knockout (marked B).
Drill four #29 mounting holes (A). Thread each hole using an 8-32 tap.
" knockout center (B) and punch using the manufacturers
1
Locate the 1- /
4
instructions.
Debur knockout and mounting holes making sure the panel stays clean
and flat.
Apply RTV to the 4 holes marked (A).
Assemble the keypad to the panel. Use 8-32 screws, nuts and lock
washers.
From the inside of the panel, apply RTV over each of the four mounting
screws and nuts. Cover a
sure to completely encapsulate the nut and washer.
" nominal diameter).
11 /
16
" area around each screw while making
3 /
4
MN715J