Table of Contents
Advertisement
Toggle CC Values
It is possible to set a toggle value for the Pedal inputs or –/+ buttons, causing it to
send one value when pressed, and another value when pressed again. One CC
value can be assigned to the – button, and a separate CC value can be assigned
to the + button. Use the Hammer 88 editor application to assign and edit the
controls on the keyboard.
When set to CC Latch, the buttons will light up in the following way:
•
When the – button's first program is selected, the – button will be blue
and dimly lit.
•
When the – button's second program is selected, the – button will be
blue and brightly lit.
•
When the + button's first program is selected, the + button will be blue
and dimly lit.
•
When the + button's second program is selected, the + button will be
blue and brightly lit.
Program Change, Bank LSB, & Bank MSB
The Pedal inputs and –/+ buttons can be configured to send a multi-part message,
consisting of a Program Change, Bank MSB, and Bank LSB message when
pressed. This is useful to select preset sounds from a specific bank on a connected
synthesizer or virtual instrument. When set to Program, the buttons will light white
temporarily when pressed. To set the Pedal inputs or –/+ buttons to send combined
Program Change, Bank MSB, and Bank LSB Messages, use the Hammer 88 editor
application.
CC Increment/Decrement
It is possible to configure the Pedal inputs and –/+ buttons to increase or decrease
a value each time it is pressed. This is useful if you want to step through values
one by one each time a pedal or button is pressed.
Each pedal will only increment or decrement its own parameter value. In other
words, assigning one pedal to increment a parameter and another to decrement
the same parameter will cause the first pedal to send values such as 1, 2, 3, etc.
Pressing the second pedal will send values such as 127, 126, 125, etc, and will
not decrement from where the first pedal left off (for example 2, 1, 0).
When set to CC Inc/Dec, each of the buttons will light up blue briefly when
pressed. The + button will only increment and the – button will only decrement.
Press + to increment to the value of 127 and then pressing the – button will
decrement the value of 126. Furthermore, pressing the – send values such as 127,
126, 125, etc, and will decrement from where the + button left off (for example 125,
126, 127.). Use the Hammer 88 editor application to change these messages.
Toggle Program Values
Using the Hammer 88 editor application, it is possible to set a toggle value for the
Pedal inputs and –/+ buttons, causing it to send one value when pressed, and
Hide quick links:
Advertisement
Table of Contents
