Table of Contents
Advertisement
WHAT TO DO IF THE GRILL IS NOT BEING USED
Thoroughly clean and dry the appliance following the instructions . Disconnect from the power supply .
WHAT TO DO IF A FAULT OCCURS
If a fault occurs switch the appliance off, disconnect via the device upstream of the appliance and notify the technical support
service .
MAINTENANCE
(Only for qualified persons)
All maintenance work must be performed by qualified personnel only .
Before beginning work, unplug or turn off the switch upstream .
ACCESS TO ELECTRICAL BOx
To access the electrical components inside the electrical box and the control elements and pilot lights, see the procedure
described in paragraph "electrical connection" points 1, 2, 3, 4 and 5 .
To remove the controls dashboard, unscrew the self-tapping screws at the top and bottom .
ACCESS TO ELECTRICAL RESISTANCES
The electrical resistances are clad in stainless steel 18/10 - AISI 304 and are housed in special profile tubes . If a resistance breaks,
ensure that the electricity supply is disconnected .
The electrical resistances are connected in groups of four per phase; once you have identified the cold area of the grill surface,
proceed as follows:
1) Slide out the ventilation element end cover and front panel (fig . 3) .
2) Raise the grill surface approx . 60° by means of the handle and prop open by means of the support (fig . 2) .
3) Unscrew the two M6 screws on the front resistance cover and remove it (fig . 2) .
4) Unscrew the front resistance stop and remove it .
5) Unscrew the rear resistance cover screw and remove it .
6) Unscrew the screws of the resistance unit in the cold area .
7) Check the resistances one by one with a tester until you find the one not working .
8) Once you have identified the resistance, slide it out of the front of the grill surface and replace with a new one .
9) Refit all the above components in reverse order .
0709
6
Hide quick links:
Advertisement
Table of Contents
