Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
THIS APPLIANCE MUST ONLY BE USED FOR THE PURPOSE IT HAS BEEN DESIGNED FOR.
The technical specifications plate is located on the controls front panel and contains all information necessary for connection .
LAWS, TECHNICAL REGULATIONS AND DIRECTIvES
The appliance must be installed in compliance with the following regulations:
1 - CURRENT SAFETY REGULATIONS
2 - INSTALLATION REGULATIONS, CEI STANDARDS
INSTALLATION
Unpack the appliance, position it, level it and adjust the height if necessary by means of the adjustable feet (fig . 1) . Remove the
protective film from the outer panels .
The master switch or socket must be near the appliance and easy to access .
You are advised to position the appliance below an extraction hood in order to ensure rapid elimination of the greasy vapours .
If the appliance is positioned near walls, partitions, kitchen units, decor panels etc ., they should be made of non-flammable
material or otherwise covered with non-flammable material .
All fire regulations must be complied with .
Model GV 819EL must be connected to a 3/8" diameter water inlet pipe and a 1 1/4" diameter water drain pipe; see table of
dimensions (1-b) .
Installation, starting up and maintenance of the appliance must be performed by qualified personnel . All installation work must
be performed in compliance with current regulations .
The manufacturer declines all liability for faulty operation due to incorrect installation .
Caution: In the event a fixed equipment does not have a power lead and plug, or any other device to disconnect it from
the electric board, which has sufficient tripping between contacts to ensure total disconnection in category III overvoltage
circumstances, the instructions must state that these disconnection devices must be installed in the electric board in compliance
with installation regulations in force .
ELECTRICAL CONNECTION
The appliance is delivered with H07 RN-F type connection cable .
If the cable has to be replaced, proceed as follows:
1) Disconnect the power supply .
2) Slide out the ventilation element end cover and front panel (fig . 3) .
3) Raise the grill surface approximately 60° via the handle and prop open by means of the support (fig . 2) .
4) Slide out the water tray (fig .6) .
5) Remove the electrical box upper panel by taking the screws out (fig . 7) .
6) Disconnect the line input terminal block cable (ref . 1 in wiring diagram) inside the rear part of the electrical box .
7) Loosen the cable grip and slide the cable out .
8) Slide the new connection cable through the cable grip, connect the leads to the corresponding terminal in the terminal block
and secure them .
9) Secure the cable with the cable grip and refit all parts in points 4 and 3 (fig . 4) in reverse order . The earth lead must be longer
than the others so that if the cable grip breaks, it detaches after the power leads .
10) Lower the grill surface via the handle .
11) Replace the ventilation element end cover and front panel .
N.B. The connection cable must be of type H07 RN-F (minimum requirement) with section adequate for the power of the
appliance, see (11) table of technical specifications.
0709
4
Hide quick links:
Advertisement
Table of Contents
