Table of Contents
Advertisement
EQUIPOTENTIAL
The appliance must be connected to an equipotential system .
The connection screw is located on the rear part of the appliance and marked by the symbol:
Caution: the manufacturer is not liable and is not required to compensate under the guarantee for damage caused by
inadequate installation and failure to follow the installation instructions.
STARTING UP
Before using the appliance for the first time it must be carefully cleaned, see paragraph "Cleaning and Maintenance" .
Check the connection of the appliance and start it following the instructions .
INSTRUCTIONS FOR USE
Caution: the appliance should not be left operating unmanned.
Remember that the grill surface becomes very hot during use .
GRILLvAPOR® appliances are designed for grilling meat, fish, vegetables, cheese etc .
SWITCH-ON
Check that the water tray is inserted . Fill the tray with water . In the 910EL series it is filled by opening the chromium-plated water
tap with blue band (fig . 7) .
Check that the grill surface is fully lowered and resting horizontally on the Grillvapor body .
Turn on the switch upstream of the appliance .
In model GV819EL it is possible to operate the grill surface in two parts at separate temperatures .
The green light indicates that the appliance is powered .
To switch the appliance on, turn the yellow knob from position "0" to "MAX" .
The yellow/orange light indicates operation of the heating element; when it goes out it means that the temperature has been
reached . In the "MAX" position the yellow/orange light remains on continuously .
To switch the appliance off, set the yellow knob to "0" .
SPECIAL INSTRUCTIONS
During use of the Grillvapor you are advised to use a steel brush to clean the grill surface .
To avoid overheating, unnecessary smoke and danger of the oil in the collecting pan catching fire, always cook with the tray
below the grill surface full of water, keeping an eye on the level during cooking (fig. 4 and fig.6).
CLEANING AND MAINTENANCE
Caution: during cleaning do not wash the outside of the appliance with direct or high pressure jets of water.
Caution: during cleaning do not wash the outside of the appliance with direct or high pressure jets of water .
Thoroughly clean the appliance every evening after work . Daily cleaning will ensure perfect operation and long life of the grill .
Disconnect the appliance before beginning cleaning . The steel parts should be washed with hot water and neutral detergent,
thoroughly rinsed to eliminate all traces of detergent and then dried with a dry cloth .
Do not use abrasive or corrosive detergents.
Cleaning of the parts in contact with the food is simple: the ventilation element end cover and front panel can be pulled out
easily and the grill surface can be raised 60° to facilitate access to the lower part - a handle with catch is provided to facilitate
raising of the grill surface and the support inside the appliance on the right props the grill surface open (fig . 2) . The water tray
can be pulled out to facilitate cleaning (fig . 5) . In the 710EL and 910EL series the tray is positioned on sliding rails and can also be
pulled out to facilitate cleaning (fig .6) . In addition, the two aforementioned series have a drain tray under the water tray which is
also extractable for thorough cleaning (fig .7) .
5
0709
Hide quick links:
Advertisement
Table of Contents
