Advertisement
USING A FREESTANDING
COMPACTOR
IN A RECESSED
AREA
1.
Measure the recessed area into which you wish
to install the compactor.
It must be at least 34-112"
(87.6cm) high, 24" (61 cm) deep, and 15118"
(38.4 cm) wide.
See
Figure 7.
3
FIGURE 7
2.
The recess must have a grounded outlet 18" min. (45cm)
above the floor as shown in Figure 8.
I
1
El
4
18" (45cm)
t
-
i
FIGURE 8
3.
Be sure the cord clip on the cord is attached to the clip on
the rear of the cabinet as shown in Figure 9.
CORD CLIP
P
FIGURE 9
4.
To prevent the power supply cord from being pinched, or
the power supply cord plug from being crushed, install a
stop block at the lower rear corners of the recessed
opening. The blocks should be at least 314" (I,9 cm)
deep by 2" (5.1 cm) wide, by 2" (5.lcm)
high. See
Figure 10 for details.
NOTE: Measure the front-toback distance of the opening.
To have the front of the compactor cabinet align with the
adjacent cabinets, the stop block may need to be more
than 3/4" (1.9cm) deep. Subtract 23" (58.4cm) from the
depth of the opening. This is the depth dimension of the
FIGURE 10
stop block.
5.
After the opening has been prepared, level the compactor
by adjusting the four leveling screws. Level unit left to right
and front to back. See Figure 11.
FIGURE 11
Plug the power supply cord into the grounded outlet.
6.
Slide the compactor back into the recess until Ihe compactor
is against the stop blocks.
ADJUSTABLE
TOE PLATE
In some installations, the toe plate may rub the floor covering.
If this occurs, the toe plate clearance
may be changed as
follows:
1.
Determine the amount of interference of the toe plate with
the floor covering.
2.
Remove the drawer from the unit. Refer to Step 4, Page
2 of the Installation Instructions.)
3.
Protect the floor. Lay drawer so the front panel
faces upward.
4.
Witharulerandapencilorchalk,drawalinewherethetoe
plate interferes with the floor covering.
5.
Use a pair of scissors and cut toe plate along this line. (See
Figure 12.)
6.
Replace drawer in unit.
CHANGING
FRONT PANEL COLOUR
?rslble
Wont
During installation, or in the future, you may wish to change the
front panel colour. Your compactor
has one revs
"
.
panel which offers two colour options. See detail of assembly
in Figure 13.
3
FIGURE 13
4152819
Advertisement
