Advertisement
INSTALLATION
INSTRUCTIONS
BEFORE YOU BEGIN, READ THE FOLLOWING
INSTRUCTIONS
COMPLETELY
AND CARE-
FULLY. THEY WILL SIMPLIFY THE INSTALLATION.
1.
After removing the shipping carton, be sure to remove all
protective packaging materials such as tape and shipping
pads. Waxy residue from protective shipping material
may be removed from compactor with a mild solution of
liquid household cleaner and water.
2.
The compactor's
overall dimensions are: Height 34.3/8"
The compactor's
overall dimensions are: Height 34.3/8"
(87.3cm), Depth 24" (6lcm), Width 15" (38.lcm).
See
(87.3cm), Depth 24" (6lcm), Width 15" (38.lcm).
See
Figure 2.
Figure 2.
(38.1 cm)
(38.1 cm)
FIGURE 2
3.
When installing your compactor, it is desirable to leave at
least 6" (15cm) clearance
from the right edge of the
drawer front for convenient bag removal.
Also allow 23"
(58.4 cm) in front of the appliance for drawer removal. See
Figure 3.
COMPACTOR
I
CABINETS
APPLttNCES
23"\
\'6"
(58.4cm)
(15cm)
FIGURE 3
4.
Remove drawer as shown:
a.
Grip handle and raise front of drawer until it clears
stops. See Figure 4.
b.
Grasp side ridges of the drawer and lift drawer out.
See Figure 5.
5.
Remove any materials shipped in the drawer and retain
for future reference.
6.
Lay two carton corner posts or other protective material
(such as a throw rug) on the floor; then lay the unit on either
of its sides on the corner posts. The corner posts will
protect the finish of the compactor
and the floor. See
Figure 6. NOTE: Do not truck or handle by console.
FIGURE 6
Remove
the cardboard
shipping
pad located on the
bottom. See Figure 6.
NOTE: Do not move or slide the compactor on the floor
until the feet have been pre-adjusted.
Pre-adjust
the
leveling feet by turning them part way out.
A suitable hand toolmay be required topre-adjust
leveling
feet.
Stand compactor upright.
FREESTANDING
INSTALLATION
Move compactor to its permanent operating location.
1.
For best drawer operation, place a small level on the top
of the unit and adjust the four leveling feet as needed.
CAUTION:
Use care so that the compactor
does not
drop on your hand.
2.
To replace the drawer, grasp side ridges of the drawer
(Figure5). Place drawer onto tracks lifting the front to clear
stops (Figure 4). Close drawer.
3.
Plug the power supply cord into the grounded receptacle.
4.
See Use and Care Guide for complete details on how to
operate and care for your TRASH MASHER* compactor
FlGlJRE 4
FIGURE 5
4152819
Advertisement
