Step 4: Setting The Speakers' Channels - Philips DVP720SA/69 User Manual

Step 4: Setting the speakers'
channels
You can adjust the delay times (centre
and surround only) and volume level for
individual speakers. These adjustments let
you optimise the sound according to your
surroundings and setup.
IMPORTANT!
The speaker settings only available on
Multi-channel audio outputs. You can
also press SURROUND button on the
remote to select Multi-channel.
1
Press STOP then, press SYSTEM
MENU.
2
Press 2 repeatedly to select {AUDIO
SETUP PAGE}.
3
Press 34 to highlight {SPEAKER SETUP},
then press 2.
4
Enter its submenu by pressing 2.
5
Press 34 to highlight one of the options
below at a time, then press 2.
{FRONT SPEAKERS, CENTER SPEAKER,
REAR SPEAKERS}
OFF – when no speaker is connected.
LARGE – when connected speakers can
produce low frequency signals below
120Hz.
SMALL – when connected speakers
cannot produce low frequency signals
below 120Hz.
To return to the previous menu, press 1.
TIPS:
To remove the menu, press
01-34 DVP720_AP2
{SUBWOOFER}
ON – when a subwoofer is connected.
OFF – when no subwoofer is connected.
{SPEAKER VOLUME} – Volume level
setting for individual speakers (-6dB ~
+6dB).
{SPEAKER DELAY} – Delay times setting
in relation to the listening position/
distance for centre and surround
speakers (1m ~ 10m).
6
Press 1 2 to adjust the setting that best
suit your surround sound needs.
7
Press OK to confirm.
Helpful Hints:
– Use the longer delay time settings when
the rear speakers are closer to the listener
than the front speakers.
– The test tone will be automatically
generated to help you judge the sound level
of each speaker.
SYSTEM MENU
15
Getting Started
.
3139 246 13522
28/07/2004, 3:29 PM
15