Table of Contents
Advertisement
Table 1
Check
Safety Requirements
This section describes safety requirements for the Cisco 6100 Series system. Before you work on the
Cisco 6100 Series system, ensure that you have met all the criteria in this section. This section describes
the following areas:
•
•
•
Safety Guidelines
Before working on the equipment, be aware of standard safety guidelines and the hazards that are
involved in working with electrical circuitry to prevent accidents. Adhere to the following cautions and
warnings for safe and hazard-free installation.
Note
To see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information for the Cisco 6100 Series System document that
accompanied this product.
In the following warnings, the terms cover panel and safety cover refer to the
Tips
Cisco 6100/6130 chassis front cover.
78-10709-03
Tool and Equipment Requirements Checklist (continued)
Tools and Equipment
Backplane screws—Included on the backplane
Wire-wrapping tool
Wire stripper
Wire for connections
12 AWG black and red copper solid or stranded—Used for Cisco 6130 chassis
•
power connections
12 AWG or thicker green or green with yellow stripes copper stranded—Used for the
•
Cisco 6130 chassis grounding
Ferrites that yield an impedance of 200 ohms +/–20 percent at 100 MHz
Tie wraps
Coaxial cable
•
Type 734A or equivalent
•
Type 735A or equivalent
Fiber cable—Used to connect the OC-3 NI-2 card
Safety Guidelines, page 3
Preventing Electrostatic Discharge Damage, page 8
General Maintenance Guidelines, page 9
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
Safety Requirements
3
Advertisement
Table of Contents
