Cisco 6130 Ni-1 To Ni-2 Conversion Procedures - Cisco 6130 NI-1 Conversion Procedure

Cisco 6130 NI-1 to NI-2 Conversion Procedures

Subtended Network Configuration with OC-3 NI-2 Cards
In a subtended network configuration using OC-3 NI-2 cards (SMF or MMF), you can subtend up to
twelve OC-3 configured chassis in a daisy chain, all connecting through one subtending host chassis to
the ATM backbone (see Figure 2).
Figure 2
Network
trunk
Cisco 6130 with NI-1 systems do not support a daisy chain subtended
Note
network configuration.
Cisco 6130 NI-1 to NI-2 Conversion Procedures
The following sections detail the procedures for converting your system from a Cisco 6130 with NI-1
system to a Cisco 6130 with NI-2 system.
Warning Only trained and qualified personnel should be allowed to install, replace, or service
this equipment.
Before installing and cabling the equipment, be aware of standard safety practices and the
Note
hazards involved in working with electrical circuitry to prevent accidents. See the "Safety
Requirements" section on page 3 for all cautions and warnings that are necessary to ensure
a safe and hazard-free installation.
To see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information for the Cisco 6100 Series System document.
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
12
Subtended Network Configuration Using OC-3 NI-2 Cards
1st subtended
Top
chassis
Cisco 6130
Cisco 6100/6130 Cisco 6100/6130
2nd subtended
chassis chassis
Cisco 6130
Cisco 6100/6130
Cisco 6130
Up to 10 more
subtended
chassis
78-10709-03