Daewoo DW-5014 Service Manual page 11


TIMER SPIN
- Function
The S pin Tim er is the sw itch providing pow er to the spin m otor(D rain P um p m otor) during the set
spin dry tim e, and is a spring-type tim e sw itch com es on upon turning and those contact point
com es off after the set tim e.
Structure and Principle of Activation
1. The m ain shaft turns due to the unw inding force w hen the spin tim er is turned and the spring w ound,
w ith that force being delivered through each gear and the spring slow ly unw inding at a speed
finally controlled by the angle assem bly.
2. The contact point turns O N and the assem bly angle is set in m otion, w hich is in the C A M groove
in the O FF state, com es off the groove w hen the M A IN S H A FT is turned to w ind the spring. The
contact point turns O FF, return to C A M groove w hen the spring unw ind com pletely.

SAFETY DEVICE FOR MO TORS
In case excessive strain is placed on the m otor
due to excessive electricity, over heating, or
overloading so that the tem perature of m otor
reaches to about 130
attached to the m otor shuts off the m otor
autom atically. In the case the m otor does not

operate, until the tem perature of m otor drops to
about 85 . It takes about an hour.

SAFETY DEVICE FOR SPIN DRYER
The spin dryer is an apparatus w hich elim inates the w ater from the laundry through centrifugal
separation generated by rapid revolution(approxim ately 1700rpm for frequency of 60H z).
A ccordingly, there are a door sw itch to cut off the pow er going into the spin m otor w hen door
spin o is opened and a brake system to stop the rotating spin dryer.

the therm al protector


  

(W hite)
9

(Violet)

(Blue)