Installing Main Board Ass'y And Power Board Ass'y - Sanyo VCC-9300 Mechanism Service Technical Information

11. Installing Main board ass'y and Power board ass'y

11-1. Install Main board ass'y 201 to the unit reassembled in Step 10-4, then tighten Screws 104 (x4).
Torque: 21.2 cN•m (2.1 kgf•cm)
Note1: Pull out the cables, from Pan motor (Motor ass'y), Tilt motor (Motor ass'y) and Slip ring, as shown below.
Note2: Keep Main board ass'y 201 pressing towards the direction of the arrow to secure with the screws 104 (x4).
11-2. Install Power board ass'y 203 to the unit reassembled in Step 11-1, then tighten Screws 104 (x4).
Torque: 21.2 cN•m (2.1 kgf•cm)
Note1: Keep Power board ass'y 203 pressing towards the direction of the arrow to secure with the screws 104 (x4).
Note2: Make sure of the clearance between Sensor and Magnet 59 .
3P connector of
Pan motor (Motor ass'y)
203
The unit reassembled
in Step 10-4
104
Screws
2x4 mm
(x4)
104
201
Main board ass'y
Figure of Steps 11-1 and 11-2
2P connector
of Slip ring
Power board ass'y
104
Keep pressing towards
the direction of the arrows
to secure with the screws.
104
Screws
2x4 mm (x4)
Keep pressing towards
the direction of the arrows
to secure with the screws.
–32–
3P connector
of Tilt motor (Motor ass'y)
5P connector
of Slip ring
0.5
1mm
Clearance
Figure of Step 11-2 and Note2