Installing The Ers 3524Gt, Ers 3524Gt-Pwr+, Ers 3526T, Or Ers 3526T-Pwr+ Switch In An Equipment Rack - Avaya 3500 Series Installing

Installation preparation
Installing the ERS 3524GT, ERS 3524GT-PWR+, ERS 3526T, or ERS
3526T-PWR+ switch in an equipment rack
Before you begin
Hardware included with ERS 3524GT/3524GT-PWR+ and ERS 3526T/3526T–PWR+
switch models:
• Avaya Ethernet Routing Switch 3500 Series
• Rack-mounting hardware that includes:
- Rack-mount brackets (2)
- Screws to attach brackets to the switch (8)
- Screws to attach the switch to the equipment rack (2x4)
• AC power cord (Note: a power cord is not included for the A variant of the switch)
• Base Software License Kit
Tool requirements
• a Phillips screwdriver to attach brackets to the switch and the switch to the rack.
Bracket requirements
• one Spare Rack Mount Kit — this kit can be used as a replacement rack mount kit for ERS
3524GT, ERS 3524GT-PWR+, ERS 3526T or ERS 3526T-PWR+ systems and must be
ordered separately (Order Code AL3511001–E6).
Rack requirements
• space of 2.8 inches (7.1 cm) (or one vertical rack width) for each switch in an E1A or 1EC
standard 19 inch (48.2 cm) equipment rack and T1A 23 inch (58.5 cm) equipment rack.
• appropriate rack space to accommodate 1U switch height (44 mm).
• rack bolted to floor and braced if necessary
• rack must be grounded to the same grounding electrode used by the power service in the
area. The group path must be permanent and must not exceed 1 Ohm of resistance from
the rack to the grounding electrode.
Perform the following procedure to install your switch in an equipment rack.
Procedure
1. Ensure power is disconnected from the switch.
2. Attach a bracket to each side of the switch with the included screws.
14 February 2013