Note
•
The type plate is located on the back of this player.
1
Connect the AC power cable to the wall
socket.
»
This player is ready to be set up for use.
4 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
Prepare the remote control
1
Press and push the battery compartment to
slide it open (see "1" in the illustration).
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Push and slide back the battery compartment
(see "3" in the illustration).
Note
•
If you are not going to use the remote control for a long
time, remove the batteries.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, so they should be
disposed of properly.
Find the TV input
1
Press
to turn on this player.
2
Turn on the TV and switch to the video input
(refer to the TV user manual on how to select
the A/V input).
Use the Home menu
1
Press
to display the home menu.
•
To start disc play, select
•
To view the USB contents, select
[browse USB].
•
To access the setup menus, select
[Setup].
Navigate a menu
1
When a menu is displayed, press the buttons
on the remote control to navigate.
Button
OK
Select a menu display language
Note
•
If this player is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this player).
1
In the Home menu, select [Setup] and press
OK.
2
Select [Preference], and press .
3
Select [Menu Language], and press .
[play Disc].
Action
Move up or down.
Move left or right.
Confirm a selection.
Enter numbers.
EN
11