Table of Contents
Advertisement
d. Choose Commit.
Note: This changes the system attention and identify indicators from the Fault state to the Normal
state.
e. Exit to the command line.
Verifying an installed part using Hardware Management Console
If you have installed or replaced a part, use the Hardware Management Console (HMC) to update your
HMC records after you have completed a service action on your server. If you have reference codes,
symptoms, or location codes that you used during the service action, locate the records for use during
this procedure.
To verify an installed part, complete these steps:
1. At the HMC, examine the service action event log for any open service action events. See Viewing
serviceable events for details.
2. Are there any service action events that are open?
No: If the system attention or identify LED is still on, use the HMC to turn off the LED. See
Activating and Deactivating LEDs. This ends the procedure.
Yes: Continue with the next step.
3. Record the list of open service action events.
4. Examine the details of the open service action event. Is the error code associated with this service
action event the same as you gathered earlier.
v No: Select one of the following options:
– Review the other serviceable events, find one that does match, and continue with the next step.
– If the log does not match what you had gathered earlier, contact your service provider.
v Yes: Continue with the next step.
5. Select and highlight the service action event from the Error Associated With This Serviceable Event
window.
6. Click Close Event.
7. Add comments for the serviceable event. Include any unique additional information. Click OK.
8. Did you replace, add, or modify a field replaceable unit (FRU) of the open service action event?
v No: Select the No FRU Replaced for this Serviceable Event option, and click OK to close the
service action event.
v Yes: Perform the following steps:
a. From the FRU list, select a FRU that you need to update.
b. Double-click the FRU and update the FRU information.
c. Click OK to close the service action event.
9. If you continue to have problems, contact your service provider.
Activating and deactivating LEDs
Use this procedure to activate or deactivate LEDs using Service Focal Point for the HMC.
Choose from the following:
v "Deactivating a system attention LED or partition LED"
v "Activating or deactivating identify LED" on page 58
Deactivating a system attention LED or partition LED:
Chapter 3. Common procedures for installable features
57
Hide quick links:
Advertisement
Table of Contents
