Maintenance - Philips AZ4000 User Manual

Digital Tuner
2 Press PROGRAM for more than
2 seconds to activate programming.
Display:
available are programmed in order of
waveband reception strength: FM,
followed by AM.The last preset
automatically stored will then be played.
Manual programming
1 Tune to your desired station
(see Tuning to stations).
2 Press PROGRAM to activate
programming.
Display:
program
flashes.
3 Press PRESET / ALBUM - or + once or
more to allocate a number from 1 to 30 to
this station.
4 Press PROGRAM again to confirm.
Display:
program
the preset number, waveband and the
frequency.
5 Repeat the above four steps to store other
stations.
appears. Stations
and a preset number
disappears, and shows

Maintenance

Maintenance
• The lens of the CD player should never be
touched!
• Sudden changes in the surrounding
temperature can cause condensation to
form and the lens of your CD player to
cloud over. Playing a CD is then not
possible. Do not attempt to clean the lens
but leave the set in a warm environment
until the moisture evaporates.
• Always shut the CD door to keep the CD
compartment dust-free.To clean, dust the
compartment with a soft dry cloth.
• To take a CD out of its box, press the
center spindle while lifting the CD. Always
pick up the CD by the edge and replace
the CD back in its box after use to avoid
scratching and dust.
• To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
• Never write on a CD or attach any stickers
to it.
• Don't expose the set, batteries or CDs to
humidity, rain, sand or excessive heat.
• Clean the set with a dry cloth. Don't use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these
may harm the set.
13