Philips DVDR7300H/05 User Manual page 79

Analogue Channel settings - Manual Search Analogue Ch.
Setup
Entry mode MHz
Entry 167.5 MHz
Preset
P 04
Analogue Ch.
Preset name RTL4
Setup
Entry mode MHz
STORE
Entry 167.5 MHz
Preset
P 04
Preset name RTL4
Analogue Ch.
Setup
STORE
Decoder Off On
PAL-BG
TV system
Nicam Off On
Analogue Ch.
Fine t une
Setup
Decoder Off On
STORE PAL-BG
TV system
Nicam Off On
Fine t une
Entry Mode
STORE
Entry
Preset
Preset name
Decorder
TV system
NICAM
Fine tuning
dvdr7300h_eu_eng2.indd 79
System Menu Options
In some cases, not all of the available TV channels may have been found
and stored during basic installation. In this case, you will need to search
for and store the missing or coded TV channels manually.
SEARCH
Press SYSTEM on the remote control. Select { Setup } in the menu
A
and press  repeatedly to select { Analogue Ch. }.
Press  repeatedly to select the following settings in the menu and
B
SEARCH
press  to enter its options.
SEARCH
Select manual search based on channel allocation or frequency entry
{ Channel, S. Channel (Special channel), MHz (frequency) }.
SEARCH
Note: S. Channel refers to specified hyperband channels.
– Use the alphanumeric keypad 0-9 to enter the frequency/channel
number, press OK and the Green button for { STORE }.
OR
– Press the Blue button on the remote control for { SEARCH }, once
you have found the correct frequency/channel, press the Green
button for { STORE }.
Use the alphanumeric keypad 0-9 to enter the preset channel number
for the channel to store (e.g., '01'), press OK and the Green button for
{ STORE }.
Use the alphanumeric keypad 0-9 to enter the preset channel name,
press OK and the Green button for { STORE }.
Maximum four characters for preset channel name.
If the current TV channel is transmitted by coded TV signals that can only
be viewed properly with a decoder which is connected to the
EXT2 AUX-I/O socket, you need to activate the connected decoder.
{ On }
– Select this to allocate the connected decoder to this
TV channel.
{ Off } – Turns off the decoder feature.
Set the TV system that produces the least distortion of picture and sound.
See "TV System Guide" for more information.
NICAM is a digital sound transmission system. It can transmit either one
stereo channel or two separate mono channels.
{ On }
– Improves the sound transmission of the TV channel.
{ Off } – Select this if the reception is poor and the sound is
distorted.
Select this to fine-tune the TV channel manually if the reception is poor.
Use   keys to adjust the frequency and press OK to confirm.
(continued)
79
2005-10-04 4:16:18 PM