Error Codes - Star Trac StairMaster Core Health & Fitness 15" Capacitive Touch OpenHub Owner's Manual

ERROR CODES

Error Codes for Treadmill, Treadclimber, Bike, Crosstrainer, and Versastrider machine configurations
Error
Name
Code
1 Model Mismatch
2 LCB Comms Lost
4 Stuck key
5 Over Speed
6 Run Away
Elevation Reverse
7
Direction
8 Elevation Range
9 Elevation Stall
10 Treadle Sensing Error
11 Battery Low
12 Speed Stall
AC Motor Error
13
Received
14 Application CRC Failed
15 Rail Stop Switch
16 Calibration Required
Display
17
Communication Lost
Page 46
Meaning/Definition
Invalid equipment configuration is currently selected.
Communications with the Lower Control board has been lost
The key switch circuit has been closed for an excessive period of time.
Speed has exceeded the maximum specified speed of the machine by 3.0 miles per
hour. An example of maximum speed on many treadmills is 12.5 miles per hour.
The belt motor is in a runaway condition. This is characterized by rapid acceleration
of the belt along with a belt speed that is in excess of the commanded speed.
The elevation motor running is running in a direction opposite of its commanded direction.
The detected position of the elevation motor is outside the allowed range of the motor.
During commanded motion, the elevation motor is failing to reach the target position.
One treadle signal has been detected changing 700 successive times or
greater without any change to the other treadle signal. Note that the end user
will observe no sign of the occurrence of the error from the console display.
However, a record of the error will be logged consistent with other system errors
only if the previous logged error entry was not a Treadle Sensor error.
The reported battery voltage from the Lower Control board
has been detected to be less than 5.7 volts DC.
Speed is being commanded but no belt movement has been detected.
The AC motor control is reporting an error to the console.
A failure of the system's application memory has been detected.
A problem with the Safety Switch circuit has been detected.
Communications between the Brain Board and the Display board has been lost.