IBM Storwize V7000 Unified Manual page 123

1. Power on the control enclosure, if it is not already powered on and configured.
2. UseTable 50 to verify the state of the LEDs on the system. Verify that no faults
Figure 62 shows the location of the LEDs on the power supply units in the rear of
the control enclosure.
1
Figure 62. LEDs on the power supply units of the control enclosure
Use the power switch on each of the two power supply units, located in the
back of the enclosure.
are detected.
Table 50. LED status when control enclosure is powered on
Hardware component
Left enclosure end cap, front
of enclosure
1
LED name
Power, top
Fault, middle
Identify, bottom
Chapter 5. Performing the hardware installation
If power on and no fault is
detected
LED is on.
LED is off.
LED is off.
103