Gas Cylinder - Napoleon BIPRO 825-3 User Manual

4
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
EN
the Eu. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.

Gas Cylinder

Use only gas cylinders that meet national and regional codes. For optimal performance the grill should be
operated on propane. The minimum cylinder size for butane units is 13 kg, and for propane units is 6 kg.
Ensure that the cylinder can provide enough fuel to operate the appliance. If in doubt, check with your
local gas supplier.
• Use caution when handling the cylinder valve.
• Never connect a cylinder, which does not meet local codes.
• Only cylinders connected to the appliance may be stored in the enclosure, or close to the appliance.
Enclosures must comply with the BUILT IN CYLINDER ENCLOSURES paragraph in the following section.
Spare cylinders must not be stored in the enclosure, or in close proximity of an operating unit.
Cylinders must not be exposed to extreme heat or direct sunlight.
Cylinder Connection: Remove the cap or plug from the cylinder fuel valve. Tighten regulator to cylinder
valve. Leak test all joints prior to using the barbecue. A leak test must be performed annually, and each
time a cylinder is hooked up, or if a part of the gas system is replaced.
Example Cylinder
Gas Hose
!
WARNING!
connected to the gas supply using hoses except to connect the cylinder regulator to the piping system.
The increased temperature within the enclosure may cause the hose to melt. Use the provided
flexible metal connector to connect the gas grill to either approved rigid piping, approved copper
tubing or approved flexible metal connectors. Ensure the installation conforms to all local and national
codes. The entire gas supply installation must be leak tested before operating the gas grill. Refer to the
manual for complete grill assembly instructions.
• If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet national and regional codes are to be used.
• Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces
on the appliance.
• Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
• The recommended hose length is 0.9m. The hose must not be longer than 1.5 m.
• Ensure that the hose is twist and kink free when installed.
• Replace the hose before expiry date printed on the hose.
www.napoleon.com
N415-0543CE-GB-DE.indd 4
306 mm
465 mm
This gas grill must be installed by a licensed gas fitter. The gas grill can not be
N415-0543CE-GB-DE JuNE 04.19
6/4/2019 2:10:59 PM