Rowenta ULTRA STEAM Instructions For Use Manual page 11

1800129617 DR6000 U1_110 x 154 23/08/13 10:46 Page5
IS THERE
Problems
The steam brush is not
plugged in.
The water tank is empty.
There is no You use the appliance for
steam.
the first time.
The steam trigger has not
been primed.
The water tank is not in
place.
It is not plugged in.
The dual voltage* is
The appliance
not set correctly.
does not heat.
Your appliance is not hot
enough.
You are using deminerali-
sed water.
Water spits.
The dual voltage* is not set
correctly.
The water tank is not in
place.
Water leaks.
The water is leaking from
the stopper.
You are using water with
additives.
The steam
leaves stains
The appliance had not
on the fabric.
been cleaned enough after
the descaling operation.
There is not The dual voltage* is not
enough power set correctly.
or too much
For any product problems or queries, please visit our website :
www.rowentausa.com or contact our Helpline on 1-800-ROWENT
PROBLEM ?
Possible causes
5
Solutions
Check that your appliance is correctly plug-
ged in.
Unplug your appliance and refill the water
tank.
When the appliance is new, press the
steam trigger press the steam trigger a few
times in vertical position.
Press the steam trigger by successive pres-
sures to begin steaming.
Ensure that the water tank snaps in when
put into place.
Plug in your appliance.
Be sure the dual voltage selector is in cor-
rect voltage position before pluging. Un-
plug the aplliance and switch the selector
to the correct voltage.
llow your steam brush to heat for ap-
proximately 50 seconds before using.
Use tap water or : 50 % untreated tap water,
50 % distilled or demineralised water.
Be sure the dual voltage selector is in cor-
rect voltage position before pluging. Un-
plug the aplliance and switch the selector
to the correct voltage.
Be sure that the water tank snaps when
put into place.
Check if the stopper is properly pushed in
place and the tong is completely inserted
in its cavity.
Never add any product in the water tank.
Read carefully the Cleaning/Descaling part.
Be sure the dual voltage selector is in
correct voltage position before pluging.
Unplug the aplliance and switch the
selector to the correct voltage.
* depending on model
EN
FR
ES