Removing Seat Pad For Cleaning; Installing Harness System - Dorel Juvenile Group COSCO Manual

Removing Seat Pad for Cleaning

You must remove the harness system to remove the pad
from the shell. See pages 9-10.
1. Release Elastic Straps on
Back and Bottom of the
Shell
2. Remove Pad
Pull pad off the bottom of child
restraint and remove pad.
WARNINGS:
Do not use child restraint without the seat
pad. Failure to do this can result in serious injury or death.
Cleaning Pad
Machine wash separately with cold water on a gentle cycle. Do not use
bleach. Tumble dry separately for 10-12 minutes on low heat. Remove
immediately.
Cleaning Harness Straps
Spot clean using warm sudsy water and damp cloth.
Replace Pad
Starting from bottom of child restraint, slip pad on shell. Pull harness
adjustment strap through pad. Wrap pad around the top of shell. Attach
all of the elastic straps. Install harness system, see pages 12-13.
11

Installing Harness System

1. Insert Buckle's Metal
Retainer into Slot
Buckle
2. Pull Metal Retainer
Completely Through
Pad and Shell
3. Check Buckle
Pull up on buckle to make sure it is
secured.
The buckle
4. Rethread Harness Strap
With sewn end of harness strap
loop facing the buckle, thread
harness strap down through hip
harness slot.
5. Pull Harness Strap Across
Bottom of Shell
Harness strap
harness adjustment strap as shown.
Push harness strap up through other
hip harness slot.
MUST face out.
MUST not pull out.
MUST lay in front
12