Programming The Remote Control For Use With A Non-Toshiba Vcr Or Cable Tv Converter - Toshiba 42H81 Owner's Manual

Programming the remote control for use with a
non-Toshiba VCR or cable TV converter
The TV remote control is pre-programmed to operate Toshiba VCRs
and cable TV converters. To use the remote control to operate a
non-Toshiba VCR or cable TV converter, follow the steps below to
program the remote control.
1. Refer to the "VCR code table" or "Cable TV converter code
table" on pages 14–15 to find the corresponding code for your
VCR or cable TV converter brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are reprogramming the remote control to operate your:
• VCR: Set the TV/CABLE/VCR switch on the remote
control to VCR.
• Cable TV converter: Set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. White holding down the RECALL button, press the Number
buttons (0-9) to enter the three-digit code for your VCR or cable
TV converter.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR responds, you have entered the correct code.
If the VCR or converter does not respond, you may have entered
the wrong code. Repeat steps 1–4 using another code.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR code _____________________
Cable TV converter code _____________________
RECALL
LIGHT RECALL POWER
POWER
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
1 2 3
Channel yz
CH
4 5 6
Channel
7 8 9
Number
VOL
CH RTN
0
100
ENT
Enter
ADV/
POP CH
MENU/
FAV FAV
ENTER
ADV/
POP CH
STOP SOURCE PLAY PIP
REC TV/VCR REW FF
Note:
STILL LOCATE SWAP
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2. " If
your VCR has this kind of switch and does
not respond to any of the codes for your
VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
13