Operating A Tv With The Remote Control - Toshiba SD-9200 Owner's Manual

Function setup
Operating a TV with the remote
control
You can operate the basic functions of selected TVs
using the supplied remote control.

Operating a TV with the remote control

Preparation
Follow the instruction of "To program the remote control" to set the brand code.
Point the remote control at your TV, and
use buttons as follows.
POWER To turn the power on and off.
TV/VIDEO To select a video input.
VOL / To adjust the volume.
CH / To select a channel.
POWER
TV/VIDEO
VOL
CH
Close the cover to
use these buttons.
66
POWER
TV/VIDEO
VOL
CH
To program the remote control
1 While holding down ENTER, press the number
buttons that correspond to your TV's brand code
referring to the list on the next page.
e.g. To Program brand code 0071.
ENTER
0 0
Hold down.
2 Release ENTER.
The DVD remote control memorizes the selected
brand code.
Notes
• The remote control is programmed at the factory to operate
TOSHIBA TVs.
• A single brand may use different codes depending on the
particular model. Enter the correct number referring to the
brand code table.
• For some brands, several brand codes are provided. Try
each of them until the remote control operates your TV.
• Some TVs may not respond to all of the functions in the
table above, or may not be operated at all with this remote
control. In this case, operate that TV with its own remote
control.
• If you replace the remote control's batteries, remember to
reprogram the brand codes for TV.
ENTER
Number buttons
7 1